Lo Sampler Pll Bw Adjustment; Phase Noise Bw Adjustment - Agilent Technologies E5052A Service Manual

Required equipment for the receiver IF gain/flatness adjustment
Description
Signal Generator
50 ohm Termination
Power Sensor
Power Meter
Power Splitter
N(m)-N(m) Cable
N(m)-N(m) Adapter

LO Sampler PLL BW Adjustment

The purpose of this procedure is to adjust the LO sampler PLL BW of the A4/A5 local
synthesize modules.
Required equipment for the LO sampler PLL BW adjustment
Description
Signal Generator
N(m)-N(m) Cable

Phase Noise BW Adjustment

The purpose of this procedure is to adjust the phase noise BW of the phase detector board.
Required equipment for the phase noise BW adjustment
Description
Signal Generator
N(m)-N(m) Cable
Chapter 3
Required Adjustment after Replacing Assembly
Recommended Model
Agilent E8257D option UNR,
UNT
Agilent 909C opt.012
Agilent 8481A
Agilent E4419A/B
Agilent 11667A
Agilent N6314A (p/n
8120-8862)
Agilent p/n 1250-1475
Recommended Model
Agilent E8257D option UNR,
UNT
Agilent N6314A (p/n
8120-8862)
Recommended Model
Agilent E8257D option UNR,
UNT
Agilent N6314A (p/n
8120-8862)
Adjustment
81