Restore Backup Files Onto The New Hdd; Adjustments For The New Hdd; Calibration Of The Touch Screen - Agilent Technologies E5052A Service Manual

A27 Removable Hard Disk Drive Replacement for E5052A Serial Prefix
Step 3. When the "Backup" in Spot Adjustment has been done, restore backup files onto the new
removable hard disk drive as described in "Restore Backup Files onto the New HDD" on
page 185.
Step 4. If the "Backup" in Spot Adjustment has not been done, restore backup files onto the new
removable hard disk drive as described in "Adjustments for the New HDD" on page 185.
Step 5. Calibrate the touch screen as described in "Calibration of the Touch Screen" on page 185.

Restore Backup Files onto the New HDD

The Backup files are stored into the PC. The file must be restored in the new removable
hard disk drive with the adjustment program. For the details of the adjustment program,
refer to Chapter 3, "Adjustment," on page 73.
Step 1. Run the adjustment program.
Step 2. Input the GPIB address of the E5052A.
Step 3. Input the serial number of the E5052A.
Step 4. Perform the adjustment using "Recovery" in Spot Adjustment of the program.

Adjustments for the New HDD

Step 1. Run the adjustment program.
Step 2. Input the GPIB address of the E5052A.
Step 3. Input the serial number of the E5052A.
Step 4. Perform the adjustment using "HDD" in Spot Adjustment of the program.

Calibration of the Touch Screen

When you have replaced the HDD on a E5052A, you have to calibrate the touch screen.
Follow the procedure described below to calibrate the touch screen.
Step 1. Press [System].
Step 2. Press Service Menu
Step 3. Press Test Menu .
Step 4. Press Adjust Touch Screen
The touch screen calibration screen (Figure 6-7) appears.
Chapter 6
.
.
Replacement Procedure
MY442 and above
185