Adjustment
Required Adjustment after Replacing Assembly
Required equipment for the PM flatness adjustment
Description
Signal Generator
Power Splitter
Power Sensor
Power Meter
N(m)-N(m) Cable
N(m)-N(m) Adapter
Receiver RF Flatness Adjustment
The purpose of this procedure is to adjust the RF flatness of the A6 phase detector board.
Required equipment for the receiver RF flatness adjustment
Description
Signal Generator
Power Amplifier (35dB)
Power Amplifier (35dB)
50 ohm (BNC) Termination
Power Sensor
Power Meter
Power Splitter
N(m)-N(m) Cable
N(m)-N(m) Adapter
Receiver IF Gain/Flatness Adjustment
The purpose of this procedure is to adjust the IF gain / flatness of the A6 phase detector
board.
80
Recommended Model
Agilent E8257D option UNR,
UNT
Agilent 11667A
Agilent 8481A
Agilent E4419A/B
Agilent N6314A (p/n
8120-8862)
Agilent p/n 1250-1475
Recommended Model
Agilent E8257D option UNR,
UNT
R & K A3000-2H-R
Agilent 83020A
Agilent 11593A
Agilent 8481A
Agilent E4419A/B
Agilent 11667A
Agilent N6314A (p/n
8120-8862)
Agilent p/n 1250-1475
Chapter 3