Debug Mpls L2Transport Vlan - Cisco Catalyst 3750 Metro Command Reference Manual

debug mpls l2transport vlan

debug mpls l2transport vlan
Use the debug mpls l2transport vlan privileged EXEC command to enable debugging of the Ethernet
over multiprotocol label switching (EoMPLS) Layer 2 VLANs. Use the no form of this command to
disable debugging.
Syntax Description
control
distributed
switching
Defaults Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.1(14)AX
Related Commands Command
debug mpls atom
show debugging
show mpls l2transport
vc
Catalyst 3750 Metro Switch Command Reference
B-38
debug mpls l2transport vlan {control | distributed | switching}
no debug mpls l2transport vlan {control | distributed | switching}
Display EoMPLS traffic control plane debug messages.
Display EoMPLS traffic distributed switching control debug messages.
Display EoMPLS traffic packet switching debug messages.
Modification
This command was introduced.
Description
Enables debugging of the Any Transport over multiprotocol label switching
(AToM) layer.
Displays information about the types of debugging that are enabled.
Displays information about the Ethernet over MPLS (EoMPLS) virtual
circuits (VCs).
Appendix B Catalyst 3750 Metro Switch Debug Commands
OL-9645-10