Line Configuration Mode - Cisco Catalyst 3750 Metro Command Reference Manual

Chapter 1 Using the Command-Line Interface
The supported commands can vary depending on the version of software in use. To view a
comprehensive list of commands, enter a question mark (?) at the prompt.
Switch(config-line)# ?
To exit line configuration mode and to return to global configuration mode, use the exit command. To
exit line configuration mode and to return to privileged EXEC mode, enter the end command, or press
Ctrl-Z.
Commands Changed in Cisco IOS 12.2(25)EY
Table 1-2
software releases before Cisco IOS Release 12.2(25)EY.
Table 1-2
Releases earlier than
Cisco IOS
Release 12.2(25)EY
debug autoqos
xconnect {destination
vc-id}
1. auto-QoS = automatic quality of service
OL-9645-10
lists describes the commands that have the same function but different syntax than they did in
Commands Changed
Cisco IOS
Release 12.2(25)EY or
later
debug auto qos
xconnect {destination
vc-id encapsulation
mpls}
Commands Changed in Cisco IOS 12.2(25)EY
Description
Enables debugging of the auto-QoS
Routes a Layer 2 packets over a specified
point-to-point virtual connection.
Catalyst 3750 Metro Switch Command Reference
1
feature.
1-5