Debug Ip Sla Trace Twamp Connection - Cisco Catalyst 3750 Metro Command Reference Manual

Appendix B Catalyst 3750 Metro Switch Debug Commands

debug ip sla trace twamp connection

Use the debug ip sla trace twamp connection command in privileged EXEC mode to display the
normal communications between a Cisco IOS IP Service Level Agreements (SLAs) Two-Way Active
Measurement Protocol (TWAMP) client and server. Use the no form of this command to disable
debugging output.
Syntax Description source-ip
ip-address
Command Modes Privileged EXEC
Command History Release
12.2(52)SE
Usage Guidelines
The debug ip sla trace twamp connection privileged EXEC command displays messages about normal
communications between the client and server during a TWAMP session.
Use the debug ip sla error twamp connection command before using the debug ip sla trace twamp
Note
connection command because the debug ip sla error twamp connection command generates less
debugging output.
The debug ip sla trace twamp connection command is supported in IPv4 networks.
The undebug ip sla trace twamp connection command is the same as the no debug ip sla trace twamp
connection command.
OL-9645-10
debug ip sla trace twamp connection [source-ip ip-address]
no debug ip sla trace twamp connection [source-ip ip-address]
(Optional) Debug IP Performance Metrics (IPPM) TWAMP connections for
the specified source. Specify the source using the client device IP address.
Modification
This command was introduced.
debug ip sla trace twamp connection
Catalyst 3750 Metro Switch Command Reference
B-23