Show Mpls L2Transport Vc - Cisco Catalyst 3750 Metro Command Reference Manual

Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
Table 2-27
Field
VC State
Trans Type
Local VC Label
Remote VC Label
Tunnel Label
This is an example of the output from the show mpls l2transport vc summary command:
Switch> show mpls l2transport vc summary
MPLS interface VC summary (active vc(s) only):
VC summary (active/non-active) by destination:
destination: 172.22.255.255, Number of locally configured vc(s): 2
This is an example of the output from the show mpls l2transport vc detail command:
Switch> show mpls l2transport vc detail
vcid: 49, type: vlan
client: Vl60 is up, destination: 192.168.255.255, Peer LDP Ident: 192.168.255.25
5:0
local label: 18, remote label: 18, tunnel label: implc-null
outgoing interface: Gi1/1/1, next hop: 10.2.0.2
Local MTU: 1500, Remote MTU: 1500
Remote interface description: Vlan60
Packet totals(in/out): 0/0
byte totals(in/out): 0/0
vcid: 50, type: vlan
client: Vl80 is not up, destination: 192.168.255.255, Peer LDP Ident: 192.168.25
5.255:0
local label: unassigned, remote label: unassigned, tunnel label: not ready
Local MTU: 1500, Remote MTU: 0
Remote interface description:
Packet totals(in/out): 0/0
byte totals(in/out): 0/0
vcid: 52, type: ether , local groupid: 3, remote groupid: 3 (vc is up)
client: Fa1/0/2 is up, destination: 192.168.255.255, Peer LDP Ident: 192.168.255
.255:0
OL-9645-10
show mpls l2 transport vc Field Descriptions
Description
The state of the VC (UP or DOWN):
UP—The VC can carry traffic between the two VC end points. A VC
is up when both the local and remote interfaces are programmed.
The local interface is programmed if the VC is configured and the
•
client interface is up.
The remote interface is programmed if the remote interface is
•
configured and there is a VC remote VC label and an IGP label.
The IGP label means that there is a label-switched path (LSP) to
the peer.
DOWN—The VC is not ready to carry traffic between the two VC end
points.
The forwarding mode used.
The VC label that a device signals to its peer device. The local VC label
determines the egress interface of a packet arriving from the MPLS
backbone.
The VC label of the remote peer device.
An IGP label used to route the packet over the MPLS backbone to the
destination device that has the egress interface.
, local groupid: 32, remote groupid: 36 (vc is up)
, local groupid: 33, remote groupid: -1 (vc is down)
Catalyst 3750 Metro Switch Command Reference

show mpls l2transport vc

2-571