Show Lacp - Cisco Catalyst 3750 Metro Command Reference Manual

Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
Table 2-24
Field
LACPDUs Sent and Recv
Marker Sent and Recv
Marker Response Sent and Recv
LACPDUs Pkts and Err
This is an example of output from the show lacp internal command:
Switch> show lacp 1 internal
Flags:
Channel group 1
Port
Fa1/0/5
Fa1/0/6
Fa1/0/7
Table 2-25
Table 2-25
Field
State
LACP Port Priority
OL-9645-10
show lacp counters Field Descriptions
S - Device is requesting Slow LACPDUs
F - Device is requesting Fast LACPDUs
A - Device is in Active mode
LACP port
Flags State Priority
SA bndl 32768
SA bndl 32768
SA bndl 32768
describes the fields in the display:
show lacp internal Field Descriptions
Description
The number of LACP packets sent and received by an interface.
The number of LACP marker packets sent and received by an
interface.
The number of LACP marker response packets sent and received
by an interface.
The number of unknown and illegal packets received by LACP
for an interface.
P - Device is in Passive mode
Admin Oper
Key Key
0x3 0x3
0x3 0x3
0x3 0x3
Description
State of the specific port. These are the allowed values:
– —Port is in an unknown state.
•
bndl—Port is attached to an aggregator and bundled with
•
other ports.
susp—Port is in a suspended state; it is not attached to any
•
aggregator.
hot-sby—Port is in a hot-standby state.
•
indiv—Port is incapable of bundling with any other port.
•
indep—Port is in an independent state (not bundled but able
•
to switch data traffic. In this case, LACP is not running on
the partner port).
down—Port is down.
•
Port priority setting. LACP uses the port priority to put ports s
in standby mode when there is a hardware limitation that
prevents all compatible ports from aggregating.
Catalyst 3750 Metro Switch Command Reference

show lacp

Port Port
Number State
0x4 0x3D
0x5 0x3D
0x6 0x3D
2-527