Cisco Catalyst 3750 Metro Command Reference Manual page 659

Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
shutdown
supply
temperature
flash
hsrp
ipmulticast
mac-notification
change
move
threshold
mdsp
ospf [cisco-specific |
errors | lsa | rate-limit |
retransmit |
state-change]
pim
invalid-pim-message
neighbor-change
rp-mapping-change
mac-notification
port-security
trap-rate value
rsvp
rtr
snmp
authentication
coldstart
linkdown
linkup
warmstart
storm-control
trap-rate value
stpx
syslog
OL-9645-10
(Optional) Generate environmental monitor shutdown traps.
(Optional) Generate environmental monitor power supply traps.
(Optional) Generate environmental monitor temperature traps.
(Optional) Enable SNMP FLASH notifications.
(Optional) Enable Hot Standby Router Protocol (HSRP) traps.
(Optional) Enable IP multicast routing traps.
(Optional) Enable MAC address notification traps.
(Optional) Enable MAC address change notification traps.
(Optional) Enable MAC address move notification traps.
(Optional) Enable MAC address table threshold traps.
(Optional) Enable Multicast Source Discovery Protocol (MSDP) traps.
(Optional) Enable Open Shortest Path First (OSPF) traps. The keywords have
these meanings:
cisco-specific—(Optional) Enable Cisco-specific traps.
•
errors—(Optional) Enable error traps.
•
lsa—(Optional) Enable link-state advertisement (LSA) traps.
•
rate-limit—(Optional) Enable rate-limit traps.
•
retransmit—(Optional) Enable packet-retransmit traps.
•
• state-change—(Optional) Enable state-change traps.
(Optional) Enable Protocol-Independent Multicast (PIM) traps.
(Optional) Enable invalid PIM message traps.
(Optional) Enable PIM neighbor-change traps.
(Optional) Enable rendezvous point (RP)-mapping change traps.
(Optional) Enable MAC address notification traps.
(Optional) Enable SNMP port security traps.
(Optional) Set the maximum number of port-security traps sent per second.
The range is from 0 to 1000; the default is 0 (no limit imposed; a trap is sent
at every occurrence).
(Optional) Enable Resource Reservation Protocol (RSVP) flow change traps.
(Optional) Enable SNMP Response Time Reporter traps.
(Optional) Enable SNMP traps.
(Optional) Enable authentication trap.
(Optional) Enable cold start trap.
(Optional) Enable linkdown trap.
(Optional) Enable linkup trap.
(Optional) Enable warmstart trap.
(Optional) Enable storm-control traps. Use the trap-rate keyword to set the
maximum number of storm-control traps sent per minute. The range is from
0 to 1000; the default is 0 (no limit is imposed; a trap is sent at every
occurrence).
(Optional) Enable SNMP STPX MIB traps.
(Optional) Enable SNMP syslog traps.
Catalyst 3750 Metro Switch Command Reference
snmp-server enable traps
2-631