Debug Ip Sla Trace Twamp Control Server - Cisco Catalyst 3750 Metro Command Reference Manual

Appendix B Catalyst 3750 Metro Switch Debug Commands

debug ip sla trace twamp control server

Use the debug ip sla trace twamp control server command in privileged EXEC mode to enable
debugging output of Cisco IOS IP Service Level Agreements (SLAs) Two-Way Active Measurement
Protocol (TWAMP) normal communications between the TWAMP server and reflector. Use the no form
of this command to disable debugging output.
Syntax Description This command has no arguments or keywords.
Command Modes
Privileged EXEC
Command History Release
12.2(52)SE
Usage Guidelines The debug ip sla trace twamp control server privileged EXEC command displays messages about
normal TWAMP session communications sent from the server to the reflector.
Use the debug ip sla error twamp control server command before using the debug ip sla trace twamp
Note
control server command because the debug ip sla error twamp control server command generates less
debugging output.
The debug ip sla trace twamp control server command is supported in IPv4 networks.
The undebug ip sla trace twamp control server command is the same as the no debug ip sla trace
twamp control server command.
OL-9645-10
debug ip sla trace twamp control server
no debug ip sla trace twamp control server
Modification
This command was introduced.
debug ip sla trace twamp control server
Catalyst 3750 Metro Switch Command Reference
B-27