Cli Command Modes - Cisco Catalyst 3750 Metro Command Reference Manual

Using the Command-Line Interface
The Catalyst 3750 Metro switch is supported by Cisco IOS software. This chapter describes how to use
the switch command-line interface (CLI) to configure software features.
For a complete description of the commands that support these features, see
Metro Switch Cisco IOS Commands."
"Catalyst 3750 Metro Switch Boot Loader Commands."
Appendix B, "Catalyst 3750 Metro Switch Debug Commands."
commands, see
information on Cisco IOS Release 12.2, see the Cisco IOS Release 12.2 Command Summary.
For task-oriented configuration steps, see the software configuration guide for this release.

CLI Command Modes

This section describes the CLI command mode structure. Command modes support specific Cisco IOS
commands. For example, the interface interface-id command only works when entered in global
configuration mode.
These are the main command modes for the switch:
•
•
•
•
•
•
Table 1-1
and how to exit that mode. The prompts listed use the default name Switch.
OL-9645-10
Appendix C, "Catalyst 3750 Metro Switch Show Platform Commands."
User EXEC
Privileged EXEC
Global configuration
Interface configuration
VLAN configuration
Line configuration
lists the main command modes, how to access each mode, the prompt you see in that mode,
C H A P T E R
For information on the boot loader commands, see
For information on the debug commands, see
For information on the show platform
Catalyst 3750 Metro Switch Command Reference
1
Chapter 2, "Catalyst 3750
Appendix A,
For more
1-1