Yamaha XVZ13TF 1999 Service Manual page 78

F Positon the clip end at upper.
G Route the AIS hose through the clip.
H Route the tail / brake light lead through the hole in
the cover at the back of the frame.
I After routing the leads, fasten them with clamp.
J Fix the connector with a clamp as shwon.
K Route the wireharness between bracket and rear
fender.
L Route the CD cord (option) outside the rear
frame into the hole on the cover.
M Make sure if the lead wires go to the left or right
side.
CABLE ROUTING
N Route the wire harness with the guide (T-bar).
O Route the AIS hose between the carburetor joints.
P The protector section must be exposed.
Q Route the antenna lead at the left side.
R To the fuel cock.
S Fasten the wire harness with a plastic clamp.
T Fasten the handlebar switch lead and remote
controller lead with a plastic clamp.
U Route the ignition coil lead downward the main
harness.
V Fasten the handlebar switch lead (left), clutch
hose and remote controler lead with a plastic
clamp.
2-44
SPEC