Yamaha XVZ13TF 1999 Service Manual page 220

A
B
CRANKCASE
11. Tighten:
S upper crankcase bolts
S lower crankcase bolts
WARNING
Always use new copper washers.
NOTE:
S Tighten the bolts in the tightening sequence
cast on the crankcase.
S Install copper washers on bolts
S Install the cable holder on bolts
S Install the washers on bolts 2 and 4 X 8 .
A Upper crankcase
B Lower crankcase
M10 bolt
40 Nm (4.0 mSkg)
M8 bolt
24 Nm (2.4 mSkg)
M6 bolt
12 Nm (1.2 mSkg)
12. Install:
S middle driven shaft bearing housing retain-
ers 1
S main axle bearing retainer 2
WARNING
Always use new screws.
CAUTION:
S Apply LOCTITE
S After tightening the middle driven shaft
bearing housing retainer screws, be sure
to stake them with a center punch.
4-76
ENG
and
28
and
22
25 Nm (2.5 mSkg)
7 Nm (0.7 mSkg)
R
on to the retainer screws.
.
30
.
32