Yamaha XVZ13TF 1999 Service Manual page 74

Front remote controller
1
TPS lead
2
Carburetor heater lead
3
Speed sensor lead
4
Main harness
5
Fuel tank breather hose
6
Audio lead
7
Coolant reservoir hose
8
Fuel hose (from fuel tank)
9
Fuel hose (from fuel pump)
10
AIS hose
11
Breather hose
12
Air cleaner case drain hose
13
Wire harness
14
Support stay
15
CABLE ROUTING
A Connect the fuel sender lead on the fuel tank.
B Route the head set lead to the switch cover on the fuel tank.
C Fasten the wire harness sub lead, antenna lead and head set lead with
a plastic clamp. Align the wire harness sub lead and mark on the head
set lead with the clamp. At the cover on the antenna lead attach a
clamp.
D Fasten the throttle cable with a plastic clamp.
E Position the throttle cable (return side) at inside of the cable holder.
F Position the throttle cable (pull side) at outside of the cable holder.
G Route the wire harness with the frame guide (T-bar).
H Fasten the speed sensor lead and wire harness.
I Align the marking tape on the head set lead, CD cord (option), antenna
lead and CB cord and fasten them, tail lead and DC outlet lead with a
plastic clamp.
J Position the lead wires on the rear fender as shown.
K Clamp the speed sensor lead in the clip on the rear arms.
2-40
SPEC