Installing The Front Brake Master Cylinder - Yamaha XVZ13TF 1999 Service Manual

FRONT AND REAR BRAKES
5. Check:
S brake reservoir hose 1
Cracks/damage/wear ! Replace.
EAS00598
INSTALLING THE FRONT BRAKE MASTER
CYLINDER
WARNING
S Before installation, all internal brake com-
ponents should be cleaned and lubricated
with clean or new brake fluid.
S Never use solvents on internal brake com-
ponents.
1. Install:
S brake master cylinder 1
NOTE:
S Install the brake master cylinder holder with
the "UP" mark facing up.
S Align the end of the brake master cylinder
holder with the punch mark a on the handle-
bar.
S First, tighten the upper bolt, then the lower bolt.
2. Install:
S copper washers 1 (New)
S brake hose 2
S union bolt 3
WARNING
Proper brake hose routing is essential to in-
sure safe motorcycle operation. Refer to
"CABLE ROUTING".
NOTE:
Turn the handlebar to the left and to the right to
make sure that the brake hose does not touch
other parts (e.g., wire harness, cables, leads).
Correct if necessary.
7-30
CHAS
Recommended brake fluid
DOT 4
10 Nm (1.0 mSkg)
30 Nm (3.0 mSkg)