Yamaha XVZ13TF 1999 Service Manual page 322

FRONT AND REAR BRAKES
2. Remove:
S brake pads 1
(along with the brake pad shims)
3. Measure:
S brake pad wear limit a
Out of specification ! Replace the brake
pads as a set.
4. Install:
S brake pad shims
(onto the brake pads)
S brake pads
NOTE:
Always install new brake pads, brake pad
shims, and a brake pad spring as a set.
a. Connect a clear plastic hose 1 tightly to the
bleed screw 2 . Put the other end of the hose
into an open container.
b. Loosen the bleed screw and push the brake
caliper pistons into the brake caliper with
your finger.
c. Tighten the bleed screw.
d. Install new brake pad shims onto the new
brake pads.
e. Install new brake pads.
7-19
CHAS
Brake pad wear limit
0.6 mm
Bleed screw
6 Nm (0.6 mSkg)