Yamaha XVZ13TF 1999 Service Manual page 308

FRONT WHEEL AND BRAKE DISCS
7-5
3. Measure:
S front wheel radial runout 1
S front wheel lateral runout 2
Over the specified limits ! Replace.
Front wheel radial runout limit
1.0 mm
Front wheel lateral runout limit
0.5 mm
4. Check:
S wheel bearings
Front wheel turns roughly or is loose ! Re-
place the wheel bearings.
S oil seals
Damage/wear ! Replace.
5. Replace:
S wheel bearings (New)
S oil seals (New)
a. Clean the outside of the front wheel hub.
b. Remove the oil seals 1 with a flat-head
screwdriver.
NOTE:
To prevent damaging the wheel, place a rag 2
between the screwdriver and the wheel surface.
c. Remove the wheel bearings with a general
bearing puller.
d. Install the new wheel bearings and oil seals
in the reverse order of disassembly.
NOTE:
Use a socket 1 that matches the diameter of
the wheel bearing outer race and oil seal.
CAUTION:
Do not contact the wheel bearing center race
2 or balls 3 . Contact should be made only
with the outer race 4 .
CHAS