Aligning The Middle Gear - Yamaha XVZ13TF 1999 Service Manual

MIDDLE GEAR
5. Install:
S bearings
(onto the universal joint driven yoke/cross
joint)
CAUTION:
Then needles can easily fall out of their
races, so check each bearing carefully. Slide
the universal joint driven yok assembly
back and forth on the bearings. If a needle is
out of place, the yoke will not go all the way
onto the bearings.
6. Press each bearing into the universal joint
driven yoke assembly with a socket of the
proper size.
NOTE:
The bearings must be inserted far enough into
the universal joint driven yoke assembly so that
circlips can be installed.

ALIGNING THE MIDDLE GEAR

1. Select:
S middle drive gear shim(-s)
NOTE:
Select the proper middle drive gear shim(-s)
whenever the crankcase or the middle gears
are replaced.
4-111
ENG