Procedure 7.28 - Incline Yoke Replacement
1.
Plug the EFX's A.C power cord into an A.C. outlet and set the on/off switch in the "on" posi-
tion.
2.
Raise the incline to its highest position (level 20).
3.
Set the on/off switch in the "off" position and remove the EFX's A.C. power cord from the
A.C. outlet.
4.
Remove the front cover per Procedure 7.21.
5.
Note the number threads above the incline yoke nut or measure the distance from the top of
the incline yoke nut to the top of the incline motor's drive screw. The replacement incline
yoke will need to be installed in the exact same position as the existing incline yoke. See
Diagram 7.29.
Diagram 7.29 - Incline Yoke Nut Position
6.
Remove the upper ramp mounting bolts, that fasten the incline yoke to the ramp. See
Diagram 7.15.
7.
If two people are available, have your assistant straddle the ramp and support it while you
slide the incline yoke out of the ramp. If you do not have two people available, straddle the
ramp and support it with one hand and slide the yoke out of the ramp with your other hand.
See Diagram 7.30.
8.
Move the incline motor forward so that it rests on the EFX's frame and carefully lower the
ramp onto the lower portion of the plastic cover.
Count Threads
Measure Distance
Incline Yoke Nut