Clearing The Memory Switches - Muratec MFX-3595 Field Engineering Manual

3.3.2 Clearing the memory switches

Resets the memory switches to factory defaults.
1. Press <Mode>, <*>, <0>, <1>.
2. Press [Mem Switch Clear].
3. Press [Yes]. The memory switches will reset to factory defaults.
3.3.3 List
• DIS detection condition
001
• PBX mode dial pause
• Redial in D.0.7 error
002
• D TMF attenuation
004
• Ring signal detect time
005
• Number of CI signal detection
• Dual ring detection
• Long ring detection
• Frequency of the CI signal
• Busy tone detection
010
• Fallback pattern
• Overseas mode
• V. 29 Echo Protect tone
• Maximum transmit speed
• Time between reception of CFR and transmission of data
011
• Interval between DCS and TCF
• Output attenuation
• TTI clock type
012
• TTI calendar type
• TTI transmit
• ECM response time
• ECM error retransmit time
• Interval between DIS and DCS
• ANSam detection
013
• V. 34 transmission
• CSI / TSI / CIG transmit
• ECM mode
• Retransmit automatically when receiving RTN / PIN signals
• Program individual autodialer attributes
015
• Sending RTC signal when transmission is canceled
• Cancel redial if T.4.1 or T.4.4 error occurs
• Action after EOR signal
• Disable DCS -bit 44 at Fine and Normal transmission
016
• Additional data on TTI transmit
• Subscriber ID transmit
• TTI (name) transmit
• Time between ANSam output and CM output
017
• Check only manually entered fax numbers in ID check transmission
• Output attenuation for VoIP (Specific Tx)
018
• Transmission speed for VoIP (Specific Tx)
• Super G3 ON/OFF for VoIP (Specific Tx)
019
• ECM Mode ON/OFF for VoIP (Specific Tx)
• Data error rate
020
• Pause one second after sending CED
• Time between ANSam output and DIS output
• Receive speed
• T1 timer
021
• Print image data when post message is not received after receiving
RTC signal
• DIS / DTC Extend field Transmit
• G3 echo receive
• Enable fax reception at printer trouble
023
• V .34 reception
3-20