Muratec MFX-3595 Field Engineering Manual page 255

Detail
Phase Error code
Error code
Rx Phase B R.1.1 2011
R.1.2 2012
2100
2101
2102
2107
2108
2109
210A
210B
210C
210D
210E
210F
2118
2119
211A
211B
R.2.3 2023
Rx Phase C R.3.1 2031
R.3.3 2033
R.3.4 2034
R.3.6 2036
R.4.4 2044
R.4.1 2041
Description
T1 time-out error No, if no
page is
received
at auto
reception
Compatibility error Yes
The receiver is a product of other
maker at closed communication
No pass code received at closed
communication
The receiver has no pass code field
at closed communication
Cannot adjust communication data
rate
Cannot adjust communication code
(MH, MR, MMR)
Cannot adjust communication code
(Normal, fine, super fine)
Cannot adjust ECM mode
Cannot adjust document width
Cannot adjust minimum
communication time
Cannot adjust document length
Cannot receive standard frame
Out-of -paper reception buffer error
Reception rejected while printing
documents
Cannot delete document for
overwrite at overwrite mode
Cannot update Flash ROM through
communication
Cannot fast remote diagnose
No answer to FTT
No answer to CFR Yes
DCN received
Hang up
Continuous error line detected
DCN received to TT
FRTN output
Memory overflow
Too long document received
Journal Redial
No Confirm the remote fax.
No Confirm the remote fax.
Closed Tx Err. Remote fax is not compatible.
Close Rx error. No passcode stored in remote fax.
Close Rx error. Passcode unmatched.
Confirm the remote fax.
Confirm the remote fax.
Out of paper reception is full.
Machine error.
Reception was stopped.
No High-speed RDS. Cannot receive data.
Confirm the remote fax.
No Confirm the remote fax.
Reception was stopped.
Cannot receive with minimum speed.
Some pages are not received correctly.
Memory over.
Received doc. is not able to receive.
4-9
Message
Occurs at manual
reception.
Normally, this error does
not occur.
Normally, this error does
not occur.
Document over 3m
Note