Muratec MFX-3595 Field Engineering Manual page 138

Memory switch 02x : Reception
Memory switch 021 :
Initial
bit
Setting
7 0 Factory use only
6 0 Factory use only
5 1 Factory use only
4 0 T1 timer
0 : 35 sec.
1 : 20 sec.
3 1 Print image data when post
message is not received
after receiving RTC signal
0 : No
1 : Yes
2 0 DIS / DTC Extend field
Transmit
0 : Yes
1 : No ( Tx until Bit No.24 of
1 0 G3 echo receive
0 1 Adjusts the delay between detection of training / TCF and sending of CFR.
Switch 1
Switch 0
Memory switch 022 : Factory use only
Memory switch 023 :
Initial
bit
Setting
7 0 Enable fax reception at
printer trouble
0: Yes
1: No (Disable reception)
6 0 V .34 reception
0 : Yes
1 : No
5 0 Factory use only
4 0 Factory use only
3 1 Factory use only
2 0 Factory use only
1 0 Factory use only
0 0 Factory use only
Memory switch 024~029 : Factory use only
Adjust
Adjusts the T1 time-out. After the machine dials the remote
machine's phone number, it begins sending CNG and waits
this amount of time before disconnecting the line.
If the received document includes the RTC, the machine prints
the data even though the following protocol is not succeeded.
Setting this switch to "1" will disable ITU-T superfine mode.
DIS / DTC)
100 ms 500 ms 800 ms 1200 ms
0 0
0 1
Adjust
This disables fax reception when the printer is printing or
printer error has occurred and the machine cannot print the re-
ceived document.
Individual setting for V.34 reception.
Usage / Comments
1 1
0 1
Usage / Comments
3-32
—
—
—
—
—
—
—
—
—