Set Background Level - Muratec MFX-3595 Field Engineering Manual

3.12.3 Stamp test mode
This mode tests the optional stamp. The stamp will be stamped on the document at a regular interval.
1. Load test documents into the automatic document feeder (ADF).
2. Press <Mode>, <*>, <0>, <9>, then select [Stamp Test Mode].
3. Press [Start] to start the feeder test.
4. Press [End] to exit the test mode.
3.12.4 Document feeding test
The feeder test discharges all documents in the automatic document feeder (ADF) at a constant speed and
displays the document total on the display.
1. Load test documents into the automatic document feeder (ADF).
2. Press <Mode>, <*>, <0>, <9>, then select [Feeder Test].
3. Select the feeder speed from four steps.
4. Select wether to scan the document face only (1-sided) or both side of the document (2-sided).
5. Press [Start] to start the feeder test.
6. Press [End] to exit the test mode.

3.12.5 Set background level

The background level is an established threshold used to help measure the reflective ability of a scanned
document. This threshold can change when CIS is replaced; therefore this mode should be used to reset the
threshold when the item is changed.
This mode allows the level to be set without erasing memory contents.
1. Press <Mode>, <*>, <0>, <9>, then select [Background level].
2. Press [Front].
3. Press [Start].
After the background level is set, the machine goes back to ready screen.
3-90