Clutch - Muratec MFX-3595 Field Engineering Manual

CLUTCH

1. Remove the Cover back. (See "PCB MAIN" on page 5-36.)
2. Disconnect the junction connector [1].
3. Remove one screw [2], then remove the Plate FG regist [3].
4. Remove the harness from the clamp [4].
5. Remove the E-ring [5] and remove the CLUTCH PRTR (RES) [6].
6. Disconnect the junction connector [7].
7. Remove two screws [8], then remove the Frame drive B [9].
8. Remove the CLUTCH PRTR (PF) [10].
9. Disconnect the junction connector [11].
10. Remove the harness from the clamp [12].
11. Remove the SR [13] and remove the CLUTCH [14].
12. Remove the harness from two clamps [15].
13. Remove the Spring C exit FG [16].
14. Remove two screws [17], then remove the Frame drive C [18].
15. Disconnect two junction connectors [19] and remove two CLUTCHs [20].
[ 19 ]
[ 20 ]
[ 18 ]
[ 20 ]
[ 17 ]
[ 1 ]
[ 19 ]
[ 7 ] [ 15 ]
[ 16 ]
[ 17 ]
[ 10 ]
[ 2 ]
[ 6 ]
[ 14 ]
[ 12 ]
[ 5 ]
[ 3 ]
[ 9 ]
[ 11 ]
[ 4 ]
[ 8 ]
[ 13 ]
5-51