Avaya G350 Administration page 76

Configuring a WAN
Initial WAN configuration
— For E1 mode:
channel-group 1 timeslots 1,3-5,7 speed 64
configures time slots numbered 1, 3-5, and 7 to be mapped in channel-group number 1,
and sets the DS0 speed to 64 kbps.
NOTE:
The default DS0 speed is 56 kbps.
6
Type
exit
G350-N#
7
Use the
the media module, the port number, the channel group number, and optionally the IP interface
number. For example:
— interface Serial 4/1:1
port number 1, with channel group number 1.
—
interface Serial 5/1:2.3
port number 1, with channel group number 2, and with IP interface number 3.
You do not need to specify an IP interface number for the first serial interface that you define on a
channel group. For each additional serial interface that you define on the channel group, use a
different IP interface number.
NOTE:
If you use the
automatically created on the entire E1 bandwidth. The channel group has the number 0. In
Step 6, use the command
port number.
NOTE:
After the serial interface is created, its default encapsulation is PPP.
8
Configure the interface encapsulation:
— For PPP encapsulation, use the
mask of the interface.
— For frame relay encapsulation, see
9
Type
exit
G350-N#
10
If needed, repeat Step 6 through Step 8 to configure additional IP interfaces on the same channel
group.
11
If needed, repeat Step 5 through Step 9 to configure additional channel groups on the same E1 or
T1 port.
12
Test the WAN configuration. See
page 80.
13
Use the
76
to return to general context. The prompt returns to:
command to enter the context of the interface. Specify the slot number of
interface Serial
enters a serial interface on the media module in slot number 4, on
enters a serial interface on the media module in slot number 5, on
framing unframed
interface Serial s/p:0
to return to general context. The prompt returns to:
Verifying the WAN configuration and testing connectivity
copy running-config startup-config
command in Step 3 for an E1 port, a channel group is
where s is the slot number and p is the
command to set the IP address and subnet
ip address
Configuring frame relay
command to save the configuration.
Administration of the Avaya G350 Media Gateway
on page 78.
on
June 2004