Arp Table Commands - Avaya G350 Administration

Dynamic ARP table entries are mappings between IP addresses and MAC addresses that the switch used
recently. Dynamic ARP table entries expire after an amount of time that you can configure. The
following figure shows how a switch adds dynamic ARP table entries:
You can remove static and dynamic entries from the ARP table. Use the
to remove the ARP table entry for the station 192.168.13.76:
G350-001# no arp 192.168.13.76

ARP table commands

Use the following commands to configure the ARP table. For more information about these commands,
see Avaya G350 Media Gateway CLI Reference, 555-245-202.
•
Use the
Use the
from the ARP table.
•
Use the
in the ARP table. Entering the
current timeout value. Use the
Administration of the Avaya G350 Media Gateway
June 2004
command to add a permanent entry to the Address Resolution Protocol (ARP) table.
arp
form of this command to remove either a static entry or a dynamically learned entry
no
command to configure the amount of time, in seconds, that an entry remains
arp timeout
arp timeout
form of this command to restore the default value (four hours).
no
no arp
command without a time parameter will display the
Configuring the router
Configuring the ARP table
command. For example,
147