Icc-Vlan; Vlan Cli Commands - Avaya G350 Administration

ICC-VLAN

When the G350 includes an ICC, the ICC connects to the G350 via an internal switch. By default, the
ICC is connected on Vlan 1. The VLAN to which the ICC connects is called the ICC-VLAN.
You can use the
VLAN interface to which you want to attach the ICC switch, and type the command the
command.
To show the current ICC-VLAN, type the
The following example sets Vlan 2 as the ICC-VLAN:
G350-???(super)# interface vlan 2
G350-???(super-if:Vlan 2)# icc-vlan
Done!
G350-???(super-if:Vlan 2)# exit
G350-???(super)# show icc-vlan
VLAN 2
G350-???(super)#

VLAN CLI commands

The following commands are used to configure VLANs. For more information about these commands,
see Avaya G350 Media Gateway CLI Reference, 555-245-202.
•
Use the
•
Use the
this VLAN to the default VLAN #1. When you clear a VLAN, all ports assigned to that VLAN
are assigned to the default VLAN #1.
•
Use the
configuration mode.
•
Use the
•
Use the
•
Use the
VLAN number must be within the range.
•
Use the
•
Use the
•
Use the
•
Use the
•
Use the
particular VLAN or all VLANs.
•
Use the
no module number is specified then information for all ports on all modules is displayed. If no
port number is specified, information for all ports on the specified module is displayed.
•
Use the
•
Use the
Administration of the Avaya G350 Media Gateway
June 2004
command to attach the ICC to a different VLAN. Enter the context of the
icc-vlan
show icc-vlan
command to delete VLANs statically configured on a port.
clear port static-vlan
clear vlan command to delete an existing VLAN and its interface, and return ports from
command to create a VLAN interface and enter the Interface VLAN
interface vlan
command to delete a VLAN interface.
no interface vlan
command to assign static VLANs to ports.
set port static-vlan
command to set the port VLAN ID (PVID). If adding a new VLAN, the
set port vlan
set port vlan-binding-mode
command to configure the VLAN tagging mode of a port.
set trunk
command to configure VLANs.
set vlan
command to display all mac entries in the CAM table for a specific vlan.
show cam vlan
command to display interface configuration and statistics for a
show interfaces vlan
command to display port VLAN binding mode information. If
show port-vlan-binding
command to display VLAN tagging information for the switch.
show trunk
command to display the VLANs configured in the switch.
show vlan
Configuring advanced switching
command from the general context.
command to define the binding method used by ports.
Configuring VLANs
icc-vlan
111