Configuring The Console Port For Modem Use - Avaya G350 Administration

Configuring the G350 for modem use

Configuring the console port for modem use

—
none
NOTE:
The
console port as well as the USB port, even if you use the command in USB interface
context.
•
Use the
•
Use the
disconnects an idle PPP incoming session. By default, there is no timeout.
•
Use the
current status of the USB port, and the identity of any USB modem connected to the USB port.
Configuring the console port for modem use
The console port is labeled CONSOLE. The console port is an RJ-45 socket that functions as a serial port.
You can connect a console device or serial modem to the console port to access the CLI. For more
information, see
You can set the console port so that it automatically detects whether a console device or a modem is
connected to it. Use the
every time an Avaya proprietary modem cable is plugged into the console port. If you do not want the
console port to automatically detect when a modem is connected to it, use the
command to disable interactive mode.
NOTE:
By default, async mode is set to
Use the following commands to configure the console port for use with a modem:
•
Use the
•
Use the
to a modem (in bits per second). Options are 9600, 19200, and 38400.
•
Use the
want to use. By default, the console port is set to work with MultiTech modems. Set this
command to null to use any modem type other than MultiTech.
•
Use the
no form of this command to set the console parameters to their default values.
•
Use the
address to which a remote user can connect using telnet. For example, to assign the IP address
192.168.22.33 with mask 255.255.255.0 to the console port, use the following command:
G350-001(if:Console)# ip address 192.168.22.33 255.255.255.0
The default IP address of the console port is 10.3.0.1 with the mask 255.255.255.0.
•
Use the
client session on the PPP server. Use this command with one of the following parameters:
—
pap
authentication.
68
— no password is sent.
command changes the PPP authentication parameters of the
ppp authentication
shutdown command to disconnect a session.
command to set the number of minutes until the system automatically
timeout absolute
show interface usb-modem
Accessing the CLI on page 25.
async mode interactive
command to reset the connected modem.
async reset-modem
speed command to set the PPP baud rate to be used by the console port when connected
command to configure the console port for the modem type you
async modem-type
command to enter the console interface configuration mode. Use the
interface console
command to assign an IP address and mask to the console port. This is the IP
ip address
command to decide the authentication method used when starting a
ppp authentication
— Password Authentication Protocol. An unencrypted password is sent for
command to display the USB interface parameters, the
command to set the console port to use modem mode
.
terminal
Administration of the Avaya G350 Media Gateway
async mode terminal
June 2004