Rip Limitations; Rip Commands - Avaya G350 Administration

RIP limitations

Configuration of RIPv1 and RIPv2 is per IP interface. Configuration must be homogeneous on all routers
on each subnetwork. That is, RIPv1 and RIPv2 routers should not be configured on the same subnetwork.
However, you can configure different IP interfaces of the G350 with different RIP versions. This
configuration is valid as long as all routers on the subnet are configured with the same version.
RIPv2 and RIPv1 are considered the same protocol with regard to redistribution to and from OSPF and
static route preferences.

RIP commands

Use the following commands to configure RIP. For more information about these commands, see Avaya
G350 Media Gateway CLI Reference, 555-245-202.
•
Use the
this command to restore the default value.
•
Use the
routing information in route updates. Use the
•
Use the
Use the
•
Use the
Version 2 packets. Use the
•
Use the
the RIP protocol. The default state is talk-listen. Use the
listening to default routes.
•
Use the
interface. Use the
•
Use the
•
Use the
interface. Use the
•
Use the
this command to disable the split-horizon mechanism. By default split-horizon is enabled.
•
Use the
form of this command to remove an entry from the list of networks.
•
Use the
Use the
•
Use the
form of this command to restore the default value, disabling RIP.
no
•
Use the
timers to their default values.
Administration of the Avaya G350 Media Gateway
June 2004
command to set the interface RIP route metric value. Use the
default-metric
distribution-list command to apply a distribution policy rule for incoming or outgoing
command to set the authentication string used on the interface.
ip rip authentication key
form of this command to clear the password.
no
ip rip authentication mode
form of this command to restore the default value, none.
no
ip rip default-route-mode
command to enable split-horizon with poison-reverse on an
ip rip poison-reverse
form of this command to disable the poison-reverse mechanism.
no
command to specify the RIP version running on the interface.
ip rip rip-version
ip rip send-receive-mode
form of this command to set the RIP to talk, that is, to send reports.
no
command to enable the split-horizon mechanism. Use the
ip rip split-horizon
command to specify a list of networks on which the RIP is running. Use the
network
redistribute command to redistribute routing information from other protocols into RIP.
form of this command to restore the default value, disable redistribution by RIP.
no
command to enable RIP and to enter the router configuration context. Use the
router rip
command to set RIP timers. Use the
timers basic
form of this command to deactivate the rule.
no
command to specify the type of authentication used in RIP
command to enable learning of the default route received by
form of this command to disable
no
command to set the RIP send and receive modes on an
form of this command to set the RIP
no
Configuring the router
Configuring RIP
form of
no
form of
no
no
151