—
chap
for authentication. To configure this password, use the
—
none
NOTE:
This command changes the PPP authentication parameters of the USB port as well as the
CONSOLE port, even if you use the command in console interface context.
•
Use the
•
Use the
disconnects an idle PPP incoming session. By default, there is no timeout.
When you use a console device to access the CLI through the console port, you must configure the serial
connection on the console device to match the configuration of the console port. The console port uses
the following settings:
•
baud — 9600
•
data bits — 8
•
parity — none
•
stop bits — 1
•
flow control — hardware
Administration of the Avaya G350 Media Gateway
June 2004
— Challenge Handshake Authentication Protocol. An encrypted password is sent
— no password is sent.
command to disconnect a session.
shutdown
timeout absolute
command to set the number of minutes until the system automatically
Configuring the G350 for modem use
Configuring the console port for modem use
ppp chap-secret
command.
69