Pcapdump - D-Link DFL-260E Reference Manual

-database
-execute={STOP | START | RESTART}
-iface
-ifacedown
-ifaceup
-lsa
-neighbor
-process=<OSPF Router Process>
-route
-snoop={ON | OFF}
-verbose
<interface>
<interface>
<lsaID>
<OSPF Area>
<OSPF Neighbor>
{HA | ALT}

2.2.63. pcapdump

Packet capturing.
Description
Packet capture engine
Usage
pcapdump
Show capture status.
pcapdump -start [<interface(s)>] [-size=<value>] [-snaplen=<value>]
[-count=<value>] [-out] [-out-nocap]
[-eth=<Ethernet Address>] [-ethsrc=<Ethernet Address>]
[-ethdest=<Ethernet Address>] [-ip=<IP4 Address>]
[-ipsrc=<IP4 Address>] [-ipdest=<IP4 Address>]
[-port=<0...65535>] [-srcport=<0...65535>]
[-destport=<0...65535>] [-proto=<0...255>] [-icmp] [-tcp]
[-udp] [-promisc] [-ipversion=<1...15>]
Chapter 2: Command Reference
Show the LSA database.
Start/stop/restart OSPF process. (Admin only)
Show interface information.
Take specified interface offline. (Admin only)
Take specified interface online. (Admin only)
Show details for a specified LSA <lsaID>.
Show neighbor information.
Required if there are >1 OSPF router processes.
Show the internal OSPF process routingtable.
Show troubleshooting messages on the console.
(Admin only)
Increase amount of information to display.
OSPF enabled interface.
OSPF enabled interface.
LSA ID.
OSPF Area.
Neighbor.
Show HA routingtable.
71