D-Link DFL-260E Reference Manual page 256

StubMetric
FilterExternal
FilterInterArea
Comments
3.90.1.1. OSPFInterface
Description
Select and define the properties of an interface that should be made a member of the Router
Process.
Properties
Interface
Type
Network
MetricType
Metric
BandwidthValue
BandwidthUnit
UseDefaultAuth
AuthType
AuthPassphrase
AuthMD5ID
AuthMD5Key
HelloInterval
RtrDeadInterval
Chapter 3: Configuration Reference
Route metric for stub area. (Optional)
Specifies the network addresses allowed to be
imported into this area from external routing
sources. (Optional)
Specifies the network addresses allowed to be
imported from other routers inside the area.
(Optional)
Text describing the current object. (Optional)
Specifies which interface in the firewall will be used
for this OSPF interface. (Identifier)
Auto, Broadcast,
Point-to-multipoint. (Default: Auto)
Specifies the network related to the configured
OSPF interface. (Optional)
Metric value or Bandwidth. (Default: MetricValue)
Specifies the routing metric for this OSPF interface.
(Default: 10)
Specifies the bandwidth for this OSPF interface.
Specifies the bandwidth unit. (Default: Mbps)
Use the authentication configuration specified in
the OSPF process. (Default: Yes)
Specifies the authentication type for the OSPF
protocol exchanges. (Default: None)
Specifies the passphrase used for authentication.
(Optional)
Specifies the MD5 key ID used for MD5 digest
authentication.
A 128-bit key used to produce the MD5 digest.
(Optional)
Specifies the number of seconds between HELLO
packets sent from the interface. (Default: 10)
If no HELLO packets are received from a neighbor
within this interval (in seconds), that neighbor
256
Point-to-point or