L2Tpv3Client - D-Link DFL-260E Reference Manual

3.72. L2TPv3Client

Description
A L2TPv3 client interface terminates L2 (Ethernet and VLAN) tunnels set up over existing IP
networks.
Properties
Name
IP
LocalNetwork
PseudowireType
Protocol
RemoteEndpoint
OriginatorIPType
OriginatorIP
IPsecInterface
AutoRouteMetric
HostName
RouterID
DHCPPassthrough
NonIPPassthrough
SNMPIndex
MemberOfRoutingTable
RoutingTable
ProxyARPAllInterfaces
Chapter 3: Configuration Reference
Specifies a symbolic name for the interface.
(Identifier)
The IP address of the L2TPv3 Client interface.
The network on "this side" of the L2TPv3 tunnel.
Specifies if L2TPv3 should tunnel Ethernet or IEEE
802.1Q (VLAN) tagged Ethernet frames. (Default:
Ethernet)
Specifies if L2TPv3 should tunnel over IP or UDP.
(Default: UDP)
The IP address of the L2TPv3 server.
Specifies what IP address to use as source IP in e.g.
NAT. (Default: LocalInterface)
Manually specified originator IP address to use as
source IP in e.g. NAT.
Use this IPsec interface to encypt the traffic to the
L2TPv3 server. (L2TP/IPsec). (Optional)
Specifies the metric for the auto-created route
used by the L2TPv3 Client. (Default: 100)
The host name for this L2TPv3 Client. (Used in the
Host Name AVP). (Optional)
Router ID. (Used in the Router ID AVP). (Optional)
Allow DHCP to pass through transparently.
(Default: No)
Allow non-IP protocols
transparently. (Default: No)
Interface index assigned by the system when
persistent interface indexes are enabled. (Default:
0)
All or Specific. (Default: All)
Specifies the PBR table to insert the interface IP
route into. It also means that the specified routing
table will be used for all routing lookups, unless
overridden by a PBR rule. (Default: main)
Always select all interfaces, including new ones, for
232
to pass through