Highavailability - D-Link DFL-260E Reference Manual

3.46. HighAvailability

Description
Configure the High Availability cluster parameters for this system.
Properties
Enabled
ClusterID
SyncIface
NodeID
HASyncBufSize
HASyncMaxPktBurst
HAInitialSilence
UseUniqueSharedMac
HADeactivateBeforeReconf
ReconfFailoverTime
HAFailoverTime
Note
This object type does not have an identifier and is identified by the name of the type
only. There can only be one instance of this type.
Chapter 3: Configuration Reference
Enable high availability. (Default: No)
A (locally) unique cluster ID to use in identifying
this group of HA firewalls. (Default: 0)
Specifies the
synchronization.
Master or Slave. (Default: Master)
How much sync data, in KB, to buffer while waiting
for acknowledgments from the cluster peer.
(Default: 1024)
The maximum number of state sync packets to
send in a burst. (Default: 20)
The number of seconds to stay silent on startup or
after reconfiguration. (Default: 5)
Use a unique shared mac address for each
interface. (Default: Yes)
Deactivate(hand over) before Reconfiguration if
Active. (Default: Yes)
Number of non-responsive seconds before failover
at HA reconf (0=immediate failover). (Default: 0)
Number of milliseconds before failover when
active HA node becomes non-responsive. (Default:
750)
183
interface used for state