D-Link DFL-260E Reference Manual page 56

Show memory statistics about the IKE enigne.
ike -delete [<ip address>] [-srcif=<Interface>] [-force]
Delete IKE SAs.
ike -connect [<IPsecTunnel>]
Setup IKE and IPsec SAs for a specified tunnel.
ike -tunnels [<IPsecTunnel>] [-num={ALL | <Integer>}] [-force]
Show configured tunnels.
ike -show [<ip address>] [-num={ALL | <Integer>}]
[-srcif=<Interface>] [-verbose] [-force]
[-tunnel=<IPsecTunnel>]
Show current IKE SAs.
ike -snoop [<ip address>] [-match] [-brief] [-off]
Enable/disable IKE snooping.
ike -ha [-clear]
Shows statistics about IKE/IPsec SAs synchronized and how many that failed to import. Sent
statistics shows how many packets that has been sent to the other cluster member when this
node was active and receive statistics show how many packets/failures it got as inactive.
ike
Show current IKE SAs.
Options
-brief
-cfgmode
-clear
-connect
-delete
-force
-ha
-match
-mem
-num={ALL | <Integer>}
-off
-show
-snoop
Chapter 2: Command Reference
Show only header information.
Show statistics for config mode pool.
Reset all statistics.
Setup IKE and IPsec SAs for a specified tunnel.
Delete IKE SAs.
Don't send notifications. Delete without delay.
Show HA synchronizing statistics for IKE/IPsec SAs.
Turn on snooping of tunnel matching.
Show memory statistics.
Maximum number of entries to show (default:
40/8).
Turn off IKE snoop.
Show information on current IKE SAs.
Enable/disable snooping of IKE messages. (Admin
only)
56