Table of Contents
Advertisement
Acoustic signals and display
The interval between the acoustic signals becomes shorter as the clearance is
reduced. A continuous tone sounds from a distance of approx. 30 cm - danger
area. From this moment on do not continue driving!
For information on setting the acoustic signals and a description of the Info-
tainment display, see
»
Infotainment manual, chapter Vehicle settings (button
CAR).
Towing a trailer
On vehicles equipped with a factory-fitted towing device, only system areas
and
» Fig. 114
are active when towing a trailer.
B
Note
The signal tones for front obstacle recognition are factory-set to be higher
than for rear obstacle recognition.
Activation/deactivation
Read and observe
and
on page 117 first.
The system is automatically activated by selecting reverse gear or pressing
the symbol button
» Fig. 114
on page 117.
This is confirmed by a short acoustic signal (the symbol in the button lights
up).
On vehicles with Version 1, the system can be deactivated by moving out of re-
verse gear.
For vehicles with Version 2, the system is deactivated by pressing the symbol
button or automatically at a speed over 10 km/h (the symbol in the but-
ton goes out).
Displaying an error
If a warning signal sounds for about 3 seconds after activating the system and
there is no obstacle close to your car, this indicates a system fault. The fault is
also indicated by the symbol flashing in the button. Seek help from a spe-
cialist garage.
Note
The system can only be activated via the symbol button at a speed of below
10 km/hr.
118
Driving
All manuals and user guides at all-guides.com
Automatic system activation when moving forward
A
Automatic activation takes place at a speed below around 10 km/h under the
following conditions.
›
The distance to the obstacle at the front is less than around 90 cm.
›
The distance to the obstacle at the front is less than around 30 cm.
After activation, the following is shown in the left pane of the Infotainment
display
Acoustic signals are sounded as of a distance from the obstacle of around
50 cm.
Automatic display can be activated/deactivated in the Infotainment
ment manual, chapter Vehicle settings (CAR button).
Cruise control system
This chapter contains information on the following subjects:
Functioning
Operating Description
The Cruise Control System (CCS) maintains a set speed without you having to
actuate the accelerator pedal.
The status where the CCS maintains the speed is referred to hereinafter as the
control.
Read and observe
and
on page 117 first.
» Fig.
116.
Introduction
Fig. 116
Infotainment display: Display
with automatic activation
»
Infotain-
119
119
Advertisement
Chapters
Table of Contents
