Attaching Server Rails - Compaq ProLiant 5500 Setup And Installation Manual

3-20 Rack-Mount Server Installation

Attaching Server Rails

1. Place the tab on a server rail at the front of the server chassis. The holes
in the server rail will line up only one way with the chassis.
2. Attach the flat side of a server rail to each side of the server chassis with
four 8-32 x 1/4-inch Phillips screws. Do not use washers with the
screws.
Figure 3-12. Attaching a server rail to the server
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only