Compaq ProLiant 5500 Setup And Installation Manual page 83

5-2 Server Configuration and Utilities
To install the SmartStart and Support Software CD:
1. With your computer turned on, locate the CD-ROM drive.
2. Open the CD-ROM tray by pressing the load/unload button.
Figure 5-1.
3. Place the SmartStart and Support Software CD in the tray (label facing
up), handling the CD from the edges, not by the flat surfaces of the disc.
4. Close the tray by again pressing the load/unload button.
Upon closing the CD tray, the SmartStart installation sequence will begin
automatically.
To configure the system and load the operating system, refer to the SmartStart
documentation provided in the Server Setup and Management pack shipped
with your server.
To manage the system, refer to the Compaq Management CD provided in the
Server Setup and Management pack shipped with your server.
Inserting a CD in the CD-ROM drive
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only