Compaq ProLiant 5500 Setup And Installation Manual page 133

7-26 Cabling for Wide-Ultra SCSI-3
SCSI Cable Usage Matrix for Duplex Mode
Continued
Note 1: A third SCSI controller card is needed to connect to hard drive backplane SCSI
inputs 0 or 1 to support duplex mode operation for this configuration.
Note 2: SCSI PORT 2 output will not operate at ultra SCSI speed if non-ultra drives are used
in the removable media bay.
Note 3: If additional external 50- to 68-pin adapters are needed, order option kit 212055-
001.
Note 4: The loopback SCSI option is not supported by the SMART-2/SL controller.
Note 5: The SCSI Port 2 Controller is connected to the SCSI Port 2 connector and external
SCSI connector. It is recommended that you use SCSI Port 2 controller for either internal or
external drives, not both.
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only