Ricoh B064 SERIES Service Manual page 469

Rev. 04/2008
SC No.
851 B IEEE 1394 I/F error
Driver setting incorrect and cannot
be used by the 1394 I/F.
USB driver is corrupted or has
become unstable and cannot be
used by the USB I/F.
860 B HDD startup error at main power on
• HDD is connected but a driver
error is detected.
• The driver does not respond with
the status of the HDD within 30
s.
861 B HDD re-try failure
At power on with the HDD detected,
power supply to the HDD is
interrupted, after the HDD is
awakened from the sleep mode, the
HDD is not ready within 30 s.
862 A Number of bad sectors exceeds allowed maximum
The number of bad sectors on the
HDD in the area for storing images
exceeds 101.
863 D HDD data read failure
The data written to the HDD cannot
be read normally, due to bad
sectors generated during operation.
864 D HDD data CRC error
During HDD operation, the HDD
cannot respond to an CRC error
query.
865 D HDD access error
HDD responded to an error during
operation for a condition other than
⇒
those for SC863, 864.
876 D Log Data Error
The log data has been corrupted at power on, while the machine was operating, or
when the machine was powered off during a print or copy cycle. The machine
should never be switched off while it is printing or copying.
876- Log data file was corrupted at
1 power on or while the machine was
operating.
SM
CÓPIA NÃO CONTROLADA
Symptom
4-31
CÓPIA NÃO CONTROLADA
B064 SERIES SERVICE MODE
Possible Cause
• 1394 I/F connection incorrect
• 1394 I/F board defective
• Controller board defective
• USB connection incorrect
• Controller board defective
• HDD is not initialized
• Level data is corrupted
• HDD is defective
• Harness between HDD and board
disconnected, defective
• HDD power connector disconnected
• HDD defective
• Controller board defective
• Execute 5832 001 to format the HDD and
replace the bad sectors. HDD
replacement is recommended because
an HDD unit that generates bad sectors
is probably of poor quality and performs
poorly.
• HDD defective
• Note: If the bad sectors are generated at
the image partition, the bad sector
information is written to NVRAM, and the
next time the HDD is accessed, these
bad sectors will not be accessed for
read/write operation.
• Data transfer did not execute normally
while data was being written to the HDD.
• HDD defective.
Format the HDD with SP5832-004.
B064 Series/B140 Series
/B246 Series/D052 Series