Dimms - Ricoh B064 SERIES Service Manual

Hide thumbs Also See for B064 SERIES:

Table of Contents

PCBS AND HDD

3.12.8 DIMMS

Read this section carefully before installation so you know how to insert the DIMMs

Follow the procedure below to connect the DIMMs to the controller board.

Incorrect insertion can damage the controller board or cause a bad

connection between the DIMM and controller contacts. If the upper contact

is pressed in and bent, the resulting poor connection could cause the

entire system to not operate.

1. Hold the ROM DIMM with the edge connector [A] pointing toward the slot and

the notch [B] on the DIMM in the upper right corner.

2. Insert the edge connector [C] into the slot at a 30-degree angle from the

surface of the board.

NOTE: If the angle is too low, the upper contact could bend.

3. Move the outside edge of the ROM DIMM up and down slightly until it works

into the connector, then gently press it down level with the controller board.

B064 Series/B140 Series

/B246 Series/D052 Series

CÓPIA NÃO CONTROLADA

CÓPIA NÃO CONTROLADA

B140R865.WMF

Table of Contents

B246 series B140 series D052 series