Copier Service Table - Ricoh B064 SERIES Service Manual

Hide thumbs Also See for B064 SERIES:
Table of Contents

Advertisement

Rev. 07/2007

5.5.2 COPIER SERVICE TABLE

SP1xxx Feed
1001*
Leading Edge Registration
Adjusts the printing leading edge registration using the trimming area pattern
(SP2902-003, No.18).
[–9~+9/0.1mm]
Specification: 3±2mm
1002*
Side-to-Side Registration
Adjusts printing side-to-side registration for each feed station, using test pattern
(SP2902-003, No.18).
These SP's should be adjusted after replacing the laser synchronization detector or
the laser optical unit.
001
Tray-1
002
Tray-2
003
Tray-3
004
Tray-4 (Japan Only)
005
By-pass Tray
006
LCT
007
Duplex Tray
1003
Registration Buckle Adjustment
Adjusts the registration motor timing. This timing determines the amount of paper
buckle at registration. (A higher setting causes more buckling.)
[–9~+9/1 mm]
001*
Tray LCT
002
Duplex Tray
003*
By-pass Tray
1104*
Fusing Temperature Control (B064)
Selects the fusing temperature control mode.
[0~1/0]
0: On/Off control
1: Phase control
If power supply to the machine is unstable, select Phase Control. The machine
must be switched off and on after this setting is changed for the new setting to take
effect.
Phase control could interfere with radio or TV reception.
1105*
Fusing Temperature Adjustment
Adjusts the fusing temperature of the hot roller for plain paper, OHP or thick paper.
001
Normal Time (Center
Thermistor)
002
Normal Time (End
Thermistors) (B140)
SM
CÓPIA NÃO CONTROLADA
SERVICE PROGRAM MODE TABLES
[–9~+9/0.1 mm]
Fusing temperature during the ready condition (and
during printing for B064)
B064: [150~230/1 degree C]
B140: [180~205/1 degree C]
Fusing temperature during the ready condition
B140: [180~205/1 degree C]
5-31
CÓPIA NÃO CONTROLADA
B064 Series/B140 Series
/B246 Series/D052 Series

Advertisement

Table of Contents
loading

This manual is also suitable for:

B246 seriesB140 seriesD052 series

Table of Contents