Auxiliary Trays - Ricoh B064 SERIES Service Manual

2000/3000 SHEET FINISHERS (B700/B701)

Auxiliary Trays

The auxiliary trays are stored in the auxiliary tray storage pocket mounted on the
back cover of the finisher.
Make sure that the customer understands the following points about these auxiliary
trays:
• The trailing edges of excessively curled or Z-folded paper can activate the tray
full sensors before the tray is actually full.
• Once the "Exit Tray Full" message displays, the job cannot continue until some
sheets are removed from the tray, even if only partially full. The trays are
designed to prevent this problem.
• The auxiliary tray for the shift tray should be installed for Z-folding jobs.
• The auxiliary tray for the proof tray should be installed only when excessively
curled paper is triggering early "Exit Tray Full" alerts.
• Normally, both auxiliary trays should be placed in the pocket mounted on the
back of the finisher.
Proof Exit Auxiliary Tray
Follow the procedures below to install the auxiliary tray for the proof tray.
1. First, remove the paper form the paper feed tray, turn it upside down, and
continue printing. This may solve the problem.
2. If the "Exit Tray Full" alerts continue,
set the proof auxiliary tray [A] on the
proof tray on the top of the finisher.
3. Make sure that the arms
auxiliary tray fit tightly over the ridges
of the proof tray below.
B064 Series/B140 Series
/B246 Series/D052 Series
CÓPIA NÃO CONTROLADA
of the
1-84
CÓPIA NÃO CONTROLADA
[A]
B246I903.WMF
SM