Service Program Mode Tables - Ricoh B064 SERIES Service Manual

SERVICE PROGRAM MODE TABLES

5.5 SERVICE PROGRAM MODE TABLES
5.5.1 SERVICE TABLE KEY
Notation
(B064)
(B140)
(B140/B246/D052)
(B246/D052)
[range/step]
Italics
*
DFU
Japan only
SEF
LEF
NIA
1
* : SP titles without these notations apply to machines of every series (B064,
B140, B246/D052).
B064 Series/B140 Series
/B246 Series/D052 Series
CÓPIA NÃO CONTROLADA
An SP for the B064/B065 only.
An SP for the B140 Series only.
An SP for both the B140 Series and the B246/D052 Series.
An SP for the B246/D052 Series only.
Example: [–9~+9/0.1 mm]
The default setting can be adjusted in 0.1mm steps in the range ±9.
Note: The default setting for each SP mode is shown on the screen
in the "Initial" box immediately below the entry box. Some of the
default settings for the B064, B140, and B246 Series are different, so
be sure to check the "Initial" box on the SP mode screen.
Comments added for reference.
An asterisk marks the SP's that are reset to their factory default
settings after an NVRAM reset.
Denotes "Design or Factory Use". Do not change this value.
The feature or item is for Japan only. Do not change this value.
Short Edge Feed
Long Edge Feed
No Information Available
5-30
CÓPIA NÃO CONTROLADA
What it means
*1
*1
SM