Wheel And Tire Combinations - Mercedes-Benz SL SERIES Operator's Manual

Table of Contents

Advertisement

Clean the wheel and wheel hub contact
X
surfaces.
Slide the wheel to be mounted onto the
X
alignment bolt and push it on.
Tighten the wheel bolts until they are fin-
X
ger-tight.
Unscrew the alignment bolt.
X
Tighten the last wheel bolt until it is finger-
X
tight.
Lowering the vehicle
G
WARNING
The wheels could work loose if the wheel nuts
and bolts are not tightened to the specified
tightening torque. There is a risk of accident.
Have the tightening torque immediately
checked at a qualified specialist workshop
after a wheel is changed.
Turn the crank of the jack counter-clock-
X
wise until the vehicle is once again standing
firmly on the ground.
Place the jack to one side.
X
Tighten the wheel bolts evenly in a cross-
X
wise pattern in the sequence indicated (:
to A). The specified tightening torque is
96 lb-ft (130 Nm).
Turn the jack back to its initial position.
X
Stow the jack and the rest of the vehicle
X
tools in the trunk again.

Wheel and tire combinations

Mercedes-AMG vehicles and vehicles
X
with AMG equipment: insert the cover
into the outer sill.
Check the tire pressure of the newly moun-
X
ted wheel and adjust it if necessary.
Observe the recommended tire pressure
(
page 571).
Y
i
When you are driving with the emergency
spare wheel mounted, the tire pressure
monitor cannot function reliably. Only
restart the tire pressure monitor when the
defective wheel has been replaced with a
new wheel.
All mounted wheels must be equipped with
functioning sensors for the tire pressure
monitor.
Wheel and tire combinations
General notes
! For safety reasons, Mercedes-Benz rec-
ommends that you only use tires and
wheels which have been approved by
Mercedes-Benz specifically for your vehi-
cle.
These tires have been specially adapted for
use with the control systems, such as ABS
®
or ESP
, and are marked as follows:
MO = Mercedes-Benz Original
R
MOE = Mercedes-Benz Original Extended
R
(tires featuring run-flat characteristics)
MO1 = Mercedes-Benz Original (only cer-
R
tain AMG tires)
Mercedes-Benz Original Extended tires
may only be used on wheels that have been
specifically approved by Mercedes-Benz.
Only use tires, wheels or accessories tes-
ted and approved by Mercedes-Benz. Cer-
tain characteristics, e.g. handling, vehicle
noise emissions or fuel consumption, may
otherwise be adversely affected. In addi-
tion, when driving with a load, tire dimen-
sion variations could cause the tires to
come into contact with the bodywork and
593
Z

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sl 400Sl 550

Table of Contents