You can select the icons that you want
COMAND to display.
If no points of interest are available, you will
see a message to this effect.
i
You also see this message if you have
selected the
No Symbols
"Map display" (
page 369).
Y
To confirm the message: press W the
X
COMAND controller.
To select a POI: select
X
and press W to confirm.
To show details for the selection: select
X
Details
and press W to confirm.
To change to the map: slide ZV the
X
COMAND controller.
You can move the map and select the map
section.
To start route calculation: select
X
and press W to confirm.
A prompt appears asking whether the point
of interest should be used as the destina-
tion.
Select
Yes
or
No
and press W to confirm.
X
i Cont.
is displayed instead of
Calculate Alternative Routes
vated in the navigation menu (
Personal POIs
General notes
i
The use of personal POIs for displaying
traffic surveillance equipment is not per-
mitted in every country. Please observe the
country-specific regulations and adapt
your speed accordingly when driving.
menu item under
Next
or
Previous
Start
Start
when
is acti-
page 351).
Y
Settings
Calling up the "Personal POIs" menu
To switch to navigation mode: press the
X
Ø button.
To show the menu: press W the COMAND
X
controller.
Select
Navi
in the main function bar by
X
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
Select
Personal POIs
X
confirm.
Displaying personal POIs on the map
The personal POIs are shown on the map with
an icon according to their category.
Call up the "Personal POIs" menu
X
(
page 341).
Y
Select
Display Personal POIs On Map
X
in the menu and press W to confirm.
You can select different categories.
Navigation
341
and press W to
Z