Mercedes-Benz SL SERIES Operator's Manual page 209

Activating/deactivating the rear view
camera
To activate: make sure that the SmartKey
X
is in position 2 in the ignition lock.
Make sure that the "Show rear view camera
X
display" function is selected in COMAND
( page 319).
Y
Engage reverse gear.
X
The area behind the vehicle is shown in the
COMAND display with guide lines.
To deactivate: the rear view camera deacti-
vates if you shift the transmission to P or after
driving forwards a short distance.
Displays in the COMAND display
The rear view camera may show a distorted
view of obstacles, show them incorrectly or
not at all. The rear view camera does not show
objects in the following positions:
very close to the rear bumper
R
under the rear bumper
R
in the area immediately above the tailgate
R
handle
! Objects not at ground level may appear to
be further away than they actually are, e.g.:
the bumper of a parked vehicle
R
the drawbar of a trailer
R
the ball coupling of a trailer tow hitch
R
the rear section of an HGV
R
a slanted post
R
Use the guidelines only for orientation.
Approach objects no further than the bot-
tom-most guideline.
Driving systems
White guide line without turning the steer-
:
ing wheel, vehicle width including the
exterior mirrors (static)
Yellow guide line at a distance of approx-
;
imately 13 ft (4.0 m) from the rear of the
vehicle
Red guide line for the vehicle width includ-
=
ing the exterior mirrors, for current steer-
ing wheel angle (dynamic)
Yellow lane marking tires at current steer-
?
ing wheel angle (dynamic)
Yellow guide line at a distance of approx-
A
imately 3 ft (1.0 m) from the rear of the
vehicle
Vehicle center axle (marker assistance)
B
Bumper
C
Red guide line at a distance of approx-
D
imately 10 in (0.25 m) from the rear of the
vehicle
The guide lines are shown when the trans-
mission is in position R.
The distance specifications only apply to
objects that are at ground level.
207
Z