Mercedes-Benz SL SERIES Operator's Manual page 356

Navigation
354
Example: route display stopped
Road name and city display when route
:
display has been stopped
Distance of the crosshair from current
;
vehicle position
To get to the current vehicle position:
X
press W to confirm the symbol for the cur-
rent vehicle position.
To change the map scale: select
X
and press W to confirm.
The scale bar appears.
Turn cVd the COMAND controller and
X
press W to confirm.
Recording the route
Notes
If you have activated COMAND and the SD
memory card has been inserted, you should
not take it out of the slot.
You can store up to 100 routes.
When you record a route, COMAND uses so-
called support points and displays the route
as a series of lines. If the route is then calcu-
lated, COMAND attempts to align the recor-
ded route with the digital map.
The support points of the route may not be on
a digitized road.
This is often the case for routes that have
been calculated using map data from other
sources.
Calling up the Routes menu
Insert the SD memory card (
X
To switch to navigation mode: press the
X
Ø button.
To show the menu: press W the COMAND
X
controller.
Select Destination
X
tem menu bar by turning cVd the
Scale
COMAND controller and press W to con-
firm.
Select Routes.
X
Starting/ending recording
Call up the Routes menu (
X
To start recording : select
X
Recording
cVd the COMAND controller and press W
to confirm.
During the recording, the recorded route is
shown behind the current vehicle position
with gray strokes (symbol for tire tracks).
To end recording: select
X
in the Routes menu by turning cVd the
page 447).
Y
in the navigation sys-
page 354).
Y
Start
in the Routes menu by turning
Stop Recording