Mercedes-Benz SL SERIES Operator's Manual page 334

Navigation
332
To select a destination: press W the
X
COMAND controller once or several times.
If COMAND is unable to assign a unique
address, you will see either the address
entry menu with the destination address or
a selection list.
Select a destination by turning cVd the
X
COMAND controller and press W to con-
firm.
If the destination is within the limits of the
digital map, COMAND attempts to assign
the destination to the map.
If the destination can be assigned, you will
see the address entry menu with the
address of the destination. If not, you will
see the Destination From Map
To start route calculation: select
X
and press W to confirm.
Entering a destination using geo-coor-
dinates
To switch to navigation mode: press the
X
Ø button.
To show the menu: press W the COMAND
X
controller.
Select Destination
X
tem menu bar by turning cVd the
COMAND controller and press W to con-
firm.
entry.
Start
in the navigation sys-
Select Using Geo-Coordinates
X
press W to confirm.
An entry menu appears.
You can now enter the latitude and longitude
coordinates with the COMAND controller or
the number keypad (
Y
To change a value: turn cVd the
X
COMAND controller.
To move the mark within the line: slide
X
XVY the COMAND controller.
To move the mark between the lines:
X
slide ZVÆ the COMAND controller.
To confirm the value: press W the
X
COMAND controller.
i
If the selected position is outside the dig-
ital map, COMAND uses the nearest digi-
tized road for route calculation. You will see
the The co-ordinates are outside
the map area message. If the selected
position is located over a body of water, you
will see the The destination is in a
body of water. Please select
another destination.
Entering a destination using Mercedes-
Benz Apps
To switch to navigation mode: press the
X
Ø button.
To show the menu: press W the COMAND
X
controller.
Select Destination
X
tem menu bar by turning cVd the
and
page 303).
message.
in the navigation sys-