Mercedes-Benz SL SERIES Operator's Manual page 101

You can use the SmartKey to open or close all
side windows simultaneously.
Close the roof ( page 101).
X
Y
Open the trunk partition (
X
Vehicles without KEYLESS-GO: point the
X
tip of the SmartKey at the door handle on
the driver's door.
Vehicles with KEYLESS-GO: the Smart-
X
Key must be within 6 ft (2 m) of the vehicle.
To open all side windows: press the %
X
button on the key until the side windows
are fully opened.
To interrupt the opening procedure:
X
release the % button.
To close all side windows: press the &
X
button on the key until the side windows
are fully closed.
To interrupt the closing procedure:
X
release the & button.
Convenience closing with KEYLESS-GO
WARNING
G
When using the convenience closing feature,
parts of the body could be trapped in the clos-
ing area when a side window is being closed.
There is a risk of injury.
Observe the complete closing procedure
when the convenience closing feature is oper-
ating. Make sure that no body parts are in
close proximity during the closing procedure.
If someone is trapped:
Release the recessed sensor surface on the
X
door handle immediately.
Pull the door handle immediately and hold
X
it until the side windows open again.
With KEYLESS-GO you can close all side win-
dows simultaneously. The KEYLESS-GO key
must be outside the vehicle. All the doors
must be closed.
page 102).
Y
X
i
X
X
If a side window can no longer be closed fully,
you must reset it.
X
X
X
X
If the side window opens again slightly:
X
X
X
Touch recessed sensor surface : on the
door handle until the side windows are fully
closed.
Make sure you only touch recessed sen-
sor surface :.
Make sure that all the side windows are
closed.
To interrupt convenience closing:
release recessed sensor surface : on the
door handle.
Resetting the side windows
Close all the doors.
Turn the SmartKey to position 1 or 2 in the
ignition lock.
Pull the corresponding switch on the door
control panel until the side window is com-
pletely closed ( page 97).
Y
Hold the switch for an additional second.
Immediately pull the corresponding switch
on the door control panel until the side win-
dow is completely closed (
Hold the switch for an additional second.
If the respective side window remains
closed after the button is released, then it
has been set correctly. If this is not the
case, repeat the steps above again.
Side windows
page 97).
Y
Z
99